The CAN I/O-module provides input and output operations in a CAN environment. It supports the CiA 401 (Device profile for generic I/O modules).

It is equipped with eight digital inputs. Each of them may be configured for pnp- or npn sensors. Three of the inputs may force interrupts for low reaction time.

The CAN I/O-module provides eight digital outputs. Five outputs are PWM capable.

Installation or update of the firmware is possible via CAN interface. The CAN inerface is also used for data transmission between the components of an application.

The module may either be sealed completely in a half-shell housing or may be mounted in a die cast metal housing.

Technical data

CAN I/O sealed in half-shell

• Size (L × W × H) 160 mm × 80 m × 20 mm
• Material: plastic (ABS UL 94 HB) sealed
• Wire connector: Mounting terminals on electronic board

CAN I/O mounted in die cast housing

• Size (L × W × H) 220 mm × 120 mm × 91 mm (closed)
• Material: die cast aluminum
• Wire connector: sealed cable entries in the housing and mounting terminals on the electronic board

Environmental conditions

• Operating temperature: −25 °C + 75 °C
• Protection level: IP67
• Vibration/impact: IEC 60068
• UL-classification: UL94 V-1

Electrical characteristics

• Input voltage: 8 V to 32 V; 1,1 A fuse
• Power consumption: max. 25 mA at Ub=24 V without peripheral components
• Power consumption of the sensors: max. 500 mA, protected by a multifuse
• Load dump level 2, complete protection in combination with other Moba components inputs:
• 8 digital, configurable for npn/pnp
• 3 of the inputs interrupt capable, active edge selectable
• All inputs opto-isolated
• Outputs:
• 8 digital, +Ub switching,
• Interfaces: CAN network up to 1 Mbit/s